Boeing and U.S. Navy successfully link piloted, unmanned Growlers

Boeing Press Release | February 4, 2020

Estimated reading time 1 minute, 44 seconds.

Boeing and the U.S. Navy successfully flew two autonomously controlled EA-18G Growlers at Naval Air Station Patuxent River as unmanned air systems, using a third Growler as a mission controller for the other two.

The test shows the ability of F/A-18 Super Hornet and EA-18G Growler pilots to remotely control fighter and attack platforms from the cockpit. Boeing Photo
The test shows the ability of F/A-18 Super Hornet and EA-18G Growler pilots to remotely control fighter and attack platforms from the cockpit. Boeing Photo

The flights, conducted during the Navy Warfare Development Command’s annual fleet experiment (FLEX) exercises, proved the effectiveness of technology allowing F/A-18 Super Hornets and EA-18G Growlers to perform combat missions with unmanned systems.

“This demonstration allows Boeing and the Navy the opportunity to analyze the data collected and decide where to make investments in future technologies,” said Tom Brandt, Boeing Manned-UnManned Teaming demonstration lead. “It could provide synergy with other U.S. Navy unmanned systems in development across the spectrum and in other services.”

Over the course of four flights, 21 demonstration missions were completed.

“This technology allows the Navy to extend the reach of sensors while keeping manned aircraft out of harm’s way,” Brandt said. “It’s a force multiplier that enables a single aircrew to control multiple aircraft without greatly increasing workload. It has the potential to increase survivability as well as situational awareness.”

Notice a spelling mistake or typo?

Click on the button below to send an email to our team and we will get to it as soon as possible.

Report an error or typo

Have a story idea you would like to suggest?

Click on the button below to send an email to our team and we will get to it as soon as possible.

Suggest a story

Leave a comment

Your email address will not be published. Required fields are marked *